Rimseal Foam Pourer RFP50F

Each unit is factory-calibrated to deliver
a specified flow at a given pressure
within the limits shown in the graph
below.

The RFP50F is a low-profile unit which
protects the foam from high winds and
guides it gently on to the tank wall.
The front shield allows fully developed
foam to emerge in a cohesive blanket
that flows intact onto the inside wall of
the tank. The stainless steel mesh at the
foam exit helps to prevent blockage
from insects and nesting birds.

For new tanks, this model can make
the most cost-effective use of foam
concentrate and water resources by
producing the designed foam solution
application rate.
400
350
300
250
200
150
100
50
0

For retrofit onto existing tanks during
refurbishment, the new Angus RFP50F
can replace existing units without
the need for expensive modification.
Accurate factory-calibration ensures
full compatibility with existing foam
concentrate induction systems, and a
2” ANSI 150 flanged inlet connection.
To further simplify installation, a fitting
kit consisting of two clamps is now
supplied as an optional extra which
facilitates installation to the tank whilst
still in use and without the need for hot
work.

Angus Rimseal Foam Equipment
is suitable for use with Angus low
expansion foam concentrates. For
hydrocarbon fuels Angus FP70,
Tankmaster or Petroseal should be
used; but for polar solvent risks Angus
Niagara or Alcoseal should be used.